Step 1. LOADING THE LABEL ROLL Push the plastic core holder gently with your thumb until it snaps out. Place the roll of labels in the cassette, being sure they will feed toward the front. Push the core holder back through the center of the roll of label until it snaps into position.
Step 2. Lift the pressure foot and pull out about 4 of the labels.
Step 3. Return the pressure foot to it's closed position.
Step 4. THREADING THE LABEL STRIP Remove the first 4 labels from the backing paper. Bend the backing paper back and thread it over the release pin and under the label guides as shown in the illustration.
Step 5. Guide the backing paper in the track on the button of the cassette. Push down on the tension release and slide the backing paper under the serrated edge. Continue feeding the backing paper until it is taut and the first label is at the dispensing point of the cassette.
|  Step 6. Tear off the excess backing paper. The cassette is now loaded and ready to be easily inserted and/or removed from the dispenser as needed.
NOTE: Whenever the cassette in placed in the dispenser, any excess backing paper must be torn off first.
Step 7. INSTALLING THE CASSETTE Tilt the cassette forward. Match the arrows on the cassette and dispenser. Rock the cassette back into position and press firmly into place.
NOTE: Excess backing paper must be torn off first.
Step 8. APPLYING Squeeze the handle to advance the label to the application point. Apply the label by rolling it on with the application roller. A slight downward pressure while pulling the dispenser back is sufficient. With a few minutes practice, you will find that it is possible to apply labels very rapidly.
Step 9. ROMOVING THE USED BACKING PAPER Tear off the used backing paper against the serrated edge whenever it begins to interfere with the operation of the dispenser. Always remove used backing paper when removing the cassette from the dispenser.
Step 10. REMOVING THE CASSETTE Push the button forward to unlock the cassette. Remove it by lifting it up and rocking it forward to clear the front locking slot on the dispenser.
Step 11. REMOVING THE EMPTY LABEL CORE Push the plastic core holder out gently with your thumb and discard the used core. If you are not installing a new roll of labels immediately push the core holder back in to avoid possible damage to the cassette.
|
